CONDITION | SUGGESTION |
|
|
|
|
Scan doesn’t stop. | Adjust the Squelch setting. It |
| may be too high. |
| Check the antenna connection. |
| Make sure the antenna is in a |
| vertical position. |
| Reception may be poor. See |
| above for suggestions. |
| It is possible that none of the |
| programmed frequencies are |
| active at the time. |
Scan doesn’t start. | Make sure there are some |
| programmed channels. |
| The scanner may be in Manual |
| mode. Press Sto begin |
| scanning. |
| The scanner may be stopped on |
| a weather frequency. Press S |
| to begin scanning. |
| Adjust the Squelch setting. It |
| may be too low. |
| All the channels may be locked |
| out. Turn off Lockout for the |
| channels you want to scan. |
Keypad won’t work. | Check the Keylock. Make sure |
| Keylock is off before |
| programming or locking out |
| channels. |
|
|
If you still cannot get satisfactory results and want additional information, or to return the unit for service, please call or write the Uniden Parts and Service Division. The address and phone number are listed in the Warranty (at the end of this manual).
23