Uniden BC95XLT manual Program Band Select Mode

Page 43

To start chain search hold mode, press Hold in chain search mode. The scanner stops searching and HOLD appears. In this mode, pressing Func + changes the search direction downward and pressing Func + changes the search

direction upward. or appears according to the current search direction.

Storing Frequencies Found During Chain Search into Channel Memory

You can store frequencies you find in chain search mode or chain search hold mode.

1.Press Func + Pgm in chain search mode or chain search hold mode. The lowest blank channel and bank appear.

2.Press E to store the frequency into the blank channel. To select another channel, press Func + or Func + before you press E. You can also press 0-9 to select the bank.

If you try to save a frequency that is already stored, the scanner sounds an error tone and displays the channel that was duplicated. If you entered the fre- quency by mistake, press . To enter the frequency anyway, press E to accept.

The scanner sets itself to program mode after you store a frequency.

Program Band Select Mode

You can use this mode to define the search range used during a chain search in each search bank. To set the scanner to program band select mode, press Func and PSrc. SRCH appears. Then select a search bank.

Special Features

43

Image 43

Contents BC95XLT Precautions PrecautionsPrecautions BC95XLT Controls and Display BC95XLT Controls and DisplayContents Page Scanning Legally FCC Wants You To KnowFCC Wants You To Know FCC Wants You To Know Introduction IntroductionFrequency Range Step Mode Transmission MHz KHz Feature Highlights Feature HighlightsFeature Highlights About This Manual Understanding Scanning What is Scanning?What is Searching? UnderstandingFeature HighlightsScanningSimplex Operation Conventional ScanningRepeater Operation Where To Obtain More InformationInformation On The Internet For more information about Uniden and our other Included With Your Scanner Included With Your ScannerSetting Up Your Scanner Setting Up Your ScannerUsing Internal Batteries Using Non-Rechargeable BatteriesSetting Up Your Scanner Using Rechargeable Batteries Setting Up Your Scanner Connecting the Antenna Using AC PowerConnecting an Optional Antenna Connecting an Extension Speaker Connecting an Earphone/HeadphoneBelt Clip Connecting to a PCAbout Your Scanner About Your ScannerHold/ C Look At The KeypadFunc + Pgm Look At The Display About Your Scanner Understanding Banks Service BanksChannel-Storage Banks Operation Turning On The Scanner Setting SquelchOperation Storing Known Frequencies Into ChannelsSearching For and Temporarily Storing Active Frequencies Service SearchScanning the Stored Channels Storing Frequencies into Channels During Service SearchManually Selecting a Channel Special Features Special FeaturesClose CallTM RF Capture Technology Setting the Close Call Options Special Features To Step Chain Search Using Close Call RF CaptureChain Search Hold Mode Chain Search ModeProgram Band Select Mode Direct Entry Search Direct Entry Search Hold Mode Search Skip Memory Delay Turning Channel-Storage Banks On and Off Priority Locking Out ChannelsUsing the Display Backlight Using KeylockTroubleshooting TroubleshootingTroubleshooting Resetting the Scanner General Use Care and MaintenanceCleaning Care and MaintenanceBirdies RepairsSpecifications SpecificationsSensitivity 12dB Sinad 21.3 MHz Optional Accessories Optional AccessoriesOne-Year Limited Warranty One-Year Limited WarrantyOne-Year Limited Warranty Page Page World Without Wires