Uniden BC340CRS owner manual Introduction

Page 13

1VOLUME Control — lets you raise or lower the level of the sound.

2SQUELCH Control — lets you set the signal level required to receive a transmission. If you open the squelch all the way, you will hear hissing between transmissions. This lets you hear weak signals, but prevents scanning. As you close squelch, a stronger signal is required to stop scanning and open audio. You normally set the control to a point just where hissing on all channels stops between transmissions.

3SCAN — press to begin scanning the channels or to resume scanning.

4ALARM Select — Set to Off to disable alarm; Set to Radio to enable the radio alarm; Set to Tone to enable the tone alarm.

5SNOOZE/Backlight — Backlight: Tap to turn the LCD backlight on for 15 seconds. Press and hold to permanently turn on the backlight. Press and hold again to turn off the backlight.

Snooze: Press while the alarm sounds to silence the alarm for 5 minutes.

6TIME Set — Use to select your desired operation: Alarm Set; Clock Set; Clock.

7HOLD — press to temporarily stop scanning, limit searching, or weather scanning and remain on the channel. The scanner displays the channel on hold. Press again to resume searching or scanning.

8E/PGM — Press to enter the Program Mode. In Program Mode, enter the desired frequency using the numeric keys. Then press E/PGM to store that frequency into the memory.

In Limit Search Mode, after entering the frequency, press E/PGM to program the upper and lower limit frequency.

90 to 9 — use the numeric keys in four basic operations:

press a numeric key to enter a frequency.

press a numeric key to change a channel using the Direct Channel Access feature.

press a numeric key while scanning to enable or disable the associated scanning bank memory bands.

10POWER — Press to turn power on and off. The time displays when power is off (standby mode).

11./CLR — this key has three functions:

press to input a decimal point when you enter a frequency.

press to cancel a numeric key input 0 to 9

press to clear an error display.

Introduction

13

Image 13
Contents BC340CRS OWNER’S Manual Precautions PrecautionsPrecautions Contents Listening to Weather Channels Scanning Legally FCC Wants You to KnowFCC Wants You to Know FCC Wants You to Know Unpacking Your Scanner Unpacking Your ScannerTelescopic Antenna BC340CRS Scanner AM Loop Antenna AC AdapterIntroduction IntroductionScan and Search Speed FeaturesIntroduction 2021 ControlsIntroduction Introduction 11 12 LCDConnecting Power Setting Up The ScannerSetting Up The Scanner Using the Backlight Connecting an AntennaSetting the Current Time Using the Alarm ClockSetting the Alarm Clock Using the Alarm ClockUsing Snooze Listening to AM/FM/TV Channels Using AM/FM/TV Channel MemoryDirectly Selecting a Channel Listening to AM/FM/TV ChannelsUsing the Scanner Memories Using the Scanner MemoriesProgramming Memories BankSelecting a Memory Setting Channel Delay Using Priority ScanScanning Memory Banks Locking/Unlocking MemoriesUsing Service Search Using Limit SearchSearching for Active Frequencies Searching for Active FrequenciesSearch Lockouts Saving a Found Frequency into a Scan MemoryListening to Weather Channels Listening to Weather ChannelsCare and Maintenance Technical Specifications Technical SpecificationsAntenna included One-Year Limited Warranty One-Year Limited WarrantyWarrantor Uniden America Corporation Uniden One-Year Limited Warranty Register Online Today