Uniden UBC785XLT manual Scanning, Bank, Scan Hold Feature, To directly access a specific channel

Scanning

1. After programming frequencies, simply press SCAN to begin		C 001
scanning. During scanning, when you rotate the VFO, you can SCAN
select the direction (↑ or ↓) you want to scan.	Bank	1234567890

2.The indicators of active banks appear on the display, and the bank being currently monitored flashes. You can deselect

banks from active scanning by entering their number on your keypad. The deselected bank indicator changes to "-", and the bank’s channels are not scanned.

Note: At least one bank must be active. You cannot deactivate all ten banks at the same time. If you try to deselect all the banks, the first bank is automatically selected.

To restore a bank for active scanning, enter the bank’s number on your keypad. The bank’s indicator will be displayed again.

SCAN

3. During normal scanning the scanner skips unprogrammed or locked out channels.

4.When a transmission is received, the scanner stops on that channel. When the transmission ends, scanning resumes automatically.

CHANNELS 1 2 3 4 5 6 7 8 9 10

Frequency Frequency

Locked Out not entered (L/O)

Scan Hold Feature

If you want to stop on a channel during scanning, press ▲/HOLD.

Note: When you press and hold SCAN for 2 seconds, the scanner will move to the smallest empty channel.

If you want to resume scanning, press RSM.

To directly access a specific channel:

There are several ways to access a specific channel quickly.

1.Press ▲/HOLD.

2.Using the keypad, enter the channel number.

3.Press ▲/HOLD again.

Another method is as follows:

1. Press ▲/HOLD.

C 001

1300.0000 FM

25cm Amateur 1

UNIDEN Group A

C1000

0000.0000

Bank 10

2.When the VFO setting is in the channel mode, rotate the VFO until the desired channel is displayed. The scanner will automatically go to Hold mode.

28