Vanguard Managed Solutions 342 Adding/Removing Data Compression Encryption Simm

Modifying Your Vanguard 342

Note

The location of the FLASH SIMM and Data Compression (DCC/DSP)/

Encryption SIMM are indicated on the motherboard as shown in Figure 3-8.

Adding/Removing

SDRAM DIMM

Adding/Removing

FLASH SIMM

Adding/Removing

Data Compression/

Encryption SIMM

Use these steps to add and remove a SDRAM DIMM:

1)Insert the DIMM into slot as shown in Figure 3-7.

2)Carefully press the DIMM into the socket.

3)Lock the DIMM into place with the locking levers.

4)To remove the DIMM, disengage the locking levers by pushing them forward, and then lift out the DIMM.

Use these steps to add and remove a FLASH SIMM:

1)At a slight angle, insert the SIMM into connector as shown in Figure 3-7.

2)Carefully press the SIMM down, pushing the locking tabs through the holes. The clips click into place.

3)To remove the SIMM, use your fingers to push back the two metal retaining clips and lift out the SIMM.

Note

FLASH SIMMs for the Vanguard 340 and 6400 Series are not compatible with the Vanguard 342. Vanguard 342 SIMMs are not compatible with the Vanguard 340 and 6400 Series. The SIMMs could be damaged.

Use these steps to add and remove a Data Compression/Encryption SIMM:

1)At a slight angle, insert the SIMM into the connector, lining up the holes with the tab as shown in Figure 3-7.

2)Carefully press the SIMM down, pushing the locking tabs through the holes. The clips click into place.

3)Lock the SIMM into place with the locking levers.

4)To remove the SIMM, use your fingers to push back the two metal retaining clips and lift out the SIMM.

3-28 Installation and Replacement