QUICK START GUIDE
TROUBLESHOOTING
Scanner not working |
|
| Scanner not decoding bar code | |
No power to scanner | Incorrect interface | Interface/power | Scanner not programmed | Bar code unreadable |
Check system power; | cable used | cables are loose | for bar code type | Ensure bar code is not |
ensure power supply, | Ensure that correct | Check for loose | Ensure scanner is | defaced; try scanning |
if required, is connected | interface cable is used | cableconnections | programmed to read type | test bar code of same |
|
|
| of bar code beingscanned | bar code type |
Distance between scanner and bar code incorrect
Move scanner closer to or further from bar code
Scanner decoding bar code, but data not transmitting to host | Scanned data incorrectly displayed on host | ||
Scanner not programmed for | Interface cable is loose | Scanner not programmed for correct host interface | |
correct host interface | Check for loose cable connections | Check scanner host parameters or edit options | |
Check scanner host parameters | |||
|
| ||
or edit options |
|
| |
SCANNER PROGRAMMING BAR CODES
Reset Defaults
Start Here if you have a USB scanner | Start Here if you have a keyboard wedge scanner | ||||||||
|
|
|
|
|
|
|
|
|
|
| USB Host Types |
|
| Keyboard Wedge Host Types |
| ||||
|
|
|
|
|
|
|
|
|
|
Set Postamble
1Erase All Rules
Enter
2Begin New Rules
4 Choose a Postamble
Send All Data
3 | Tab |
|
<Enter>
5
<Tab>
Save All Rules
NOTE If you do not need a Postamble scan 1 Erase All Rules only.
BEEPER INDICATIONS
Standard Use
Low/medium/high beep | Short high beep | 4 long low beeps |
Power up | Bar code decoded [if | Transmission error |
| decode beeper enabled] | detected; data is ignored |
LED INDICATIONS
Off
Scanner is on and ready to scan, or no power to scanner
Parameter Menu Scanning |
| Green | ||
| Bar code is | |||
|
|
|
| |
High/low/high/low beep | High/low beep | Low/high beep | successfully decoded | |
Successful parameter | Correct programming | Incorrect programming |
| |
setting | sequence performed | sequence or Cancel bar | Red | |
|
|
| code scanned | Transmission error |
|
|
|
| |
|
|
|
| |
|
| ©2005 Wasp Technologies. All rights reserved. |
| |
|
| Wasp reserves the right to make changes to any product to improve reliability, function, or design. Wasp does not assume any product liability arising out of, or in connection with, the | ||
|
| application or use of any product, circuit, or application described herein. No license is granted, either expressly or by implication, estoppel, or otherwise under any patent right or patent, | ||
|
| covering or relating to any combination, system, apparatus, machine, material, method, or process in which Wasp products might be used. An implied license exists only for equipment, | ||
|
| circuits, and subsystems contained in Wasp products. Wasp and the Wasp logo are registered trademarks of Wasp Technologies. Other product names mentioned in this manual may be | ||
|
| |||
w w w . w a s p b a r c o d e . c o m | trademarks or registered trademarks of their respective companies and are hereby acknowledged. |
| ||
Wasp Technologies, 1400 10th Street, Plano, TX 75074, www.waspbarcode.com |
| |||