Wasp Bar Code W-300 manual Ribbon Take-up Holder Empty Core

Page 11

Quick Setup Guide

Loading the RIbbon

Ribbon Take-up Holder

Empty Core

6.Insert empty core into the outer ribbon supply take-up holder. (First snap in left side by aligning notches in the core to the notches on the take-up wheel.Then snap in the right side.)

7

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Thermal Label Printer User’s Guide Page Table of Contents Page Inspecting the Printer Connection Diagram Parallel Interface Requirements Power SupplyLoading the Ribbon Release Lever Notch Empty Core Ribbon Ribbon Take-up Holder Empty Core Turn the take-up wheel forward and rewind the excess ribbon Loading the Media Remove the media holder Media Compartment Media Roll Media Guides Feed Button Performing Calibration Printing Configuration ReportOperator Controls Resetting the Printer to Factory Default Settings Printer Driver Installing DriverPorts Setting Printer PropertiesSetting Printer Properties Possible Solutions Refer to Pages Problems TroubleshootingChapter Miscellaneous Printer Maintenance Technical Specifications Product Support Page
Top Page Image Contents