Wasp Bar Code W-300 manual Performing Calibration, Printing Configuration Report

Page 18

Quick Setup Guide

Calibrating the Printer

Performing Calibration

Note: This step is very important and must always be carried out whenever media is being changed. Failure to do so will result in mis-detection of the label size.

1.Press and hold the feed button while turning on the power until the printing motor becomes activated.

2.The calibration is complete when the printer automatically feeds the label stock.

3.Press feed button one more time to line label up for printing.

Printing Configuration Report

1.Press and hold the feed button while turning on the power.

2.Continue holding down the feed button.The printer will begin to feed approximately 12” of blank media. The printer will then print a configuration report.This report states the firmware version, ROM checksum, RS232, thermal transfer/direct thermal settings, hardware configuration and font types.

14

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Thermal Label Printer User’s Guide Page Table of Contents Page Inspecting the Printer Connection Diagram Power Supply Parallel Interface RequirementsLoading the Ribbon Release Lever Notch Empty Core Ribbon Ribbon Take-up Holder Empty Core Turn the take-up wheel forward and rewind the excess ribbon Loading the Media Remove the media holder Media Compartment Media Roll Media Guides Feed Button Printing Configuration Report Performing CalibrationOperator Controls Resetting the Printer to Factory Default Settings Installing Driver Printer DriverSetting Printer Properties PortsSetting Printer Properties Troubleshooting Possible Solutions Refer to Pages ProblemsChapter Miscellaneous Printer Maintenance Technical Specifications Product Support Page
Top Page Image Contents