Wasp Bar Code W-300 manual Troubleshooting, Possible Solutions Refer to Pages Problems

Page 24

Chapter 5

Troubleshooting

Troubleshooting

Normally, when the printer has an error, the “Power” or the “Ready”LED will blink.

To understand the problem, please check both LEDs first:

A. Power and Ready LEDs blink at the same time

Possible		Solutions	Refer to Pages
Problems

Mis-detected	• Check the label path		10-14
the label gap.	• Check the label sensor

Label stock	•	Reload labels	10-14
empty

Label stock	•	Reinstall the label roll	10-14
not installed
properly

Label jam	• Check media path and		10-14
		print head for possible
		media errors

20

Image 24

Contents Thermal Label Printer User’s Guide Page Table of Contents Page Inspecting the Printer Connection Diagram Power Supply Parallel Interface RequirementsLoading the Ribbon Release Lever Notch Empty Core Ribbon Ribbon Take-up Holder Empty Core Turn the take-up wheel forward and rewind the excess ribbon Loading the Media Remove the media holder Media Compartment Media Roll Media Guides Feed Button Printing Configuration Report Performing CalibrationOperator Controls Resetting the Printer to Factory Default Settings Installing Driver Printer DriverSetting Printer Properties PortsSetting Printer Properties Troubleshooting Possible Solutions Refer to Pages ProblemsChapter Miscellaneous Printer Maintenance Technical Specifications Product Support Page