Wasp Bar Code W-300 manual Resetting the Printer to Factory Default Settings

Page 20

Chapter 2

Resetting the Printer

Resetting the Printer to Factory Default Settings

1.Turn on the printer and wait for approximately 5 seconds.

2.Press the “Feed”button for 10 seconds. The “Ready”indicator and “Power” indicator will go off in order.

3.When the two indicators become lit again, release the feed button.

4.At this moment, the printer will feed 12 inches of label stock, and will reset itself to the factory default settings.

Note: All settings are stored in non-volatile EPROM and cannot be erased when the printer is turned off.

16

Image 20

Contents Thermal Label Printer User’s Guide Page Table of Contents Page Inspecting the Printer Connection Diagram Power Supply Parallel Interface RequirementsLoading the Ribbon Release Lever Notch Empty Core Ribbon Ribbon Take-up Holder Empty Core Turn the take-up wheel forward and rewind the excess ribbon Loading the Media Remove the media holder Media Compartment Media Roll Media Guides Feed Button Printing Configuration Report Performing CalibrationOperator Controls Resetting the Printer to Factory Default Settings Installing Driver Printer DriverSetting Printer Properties PortsSetting Printer Properties Troubleshooting Possible Solutions Refer to Pages ProblemsChapter Miscellaneous Printer Maintenance Technical Specifications Product Support Page