VIPowER VP-6048, VP-6049 Installation, CD-ROM Box Enclosure Features, Unpacking Your CD-ROM Box

1-1.1 CD-ROM Box Enclosure Features

•Enables portable use of 5.25” internal model removable media devices with computers equipped with the same interface

•Supports hot-swap and plug-and-play features of the selected interface

•Model VP-6020:enables cross-platform interface compatibility of 5.25” form factor IDE/ATA/ATA devices and ATAPI CD-ROM drives with computers using the same interface as the Docking Kit model (USB, Parallel, 1394/FireWire, SCSI, CARDBUS and PCMCIA).

1-1.2 Unpacking Your CD-ROM Box

Verify that the following items are included in the carton. If any parts are damaged or missing, please contact your local dealer or sales representative immediately.

•One assembled CD-ROM Box Enclosure

•One vertical-holder stand (for optional use)

•Four mounting screws

•Installation Guide

2-1 Installation

The following sections will guide you through the installation of a CD-ROM drive in the CD-ROM Box Enclosure. There are two parts to the installation:

•Disassembly of the CD-ROM Box Enclosure (as it is shipped)

•Assembly of a device in the CD-ROM Box Enclosure

A small Phillips screwdriver is the only tool required.

2-1.1 Disassemble the CD-ROM Box

1.Remove the four rubber stands on the CD-ROM Box Enclosure by gently prying them off.

2.Remove the four retaining screws securing the top enclosure cover. (Refer to the following illustration to identify the top cover.)

3.Separate the top and bottom enclosure covers.

4.Slide out the end-panel with mounted connectors and fan .

Note that the CD-ROM Box Enclosure is factory assembled with the drive rails installed.

2 CD-ROM Box Enclosure Installation Guide