a.Attach the IDE 40-pin data cable from the end-panel to the 40-pin connector on the back of the CD-ROM drive. To ensure pin-1 to pin-1 connection, orient the cable so the colored stripe edge is closest to the power connector.
b.Attach the 4-pin power cable from the end-panel to the 4-pin connector on the back of the CD-ROM drive. The connector is ‘D’ shaped to ensure proper connection.
2.Place the CD-ROM drive in the bottom enclosure cover. The CD-ROM drive’s front face panel should be flush with the front corners of the case (positioned in front of the guide flanges.)
3.Align the CD-ROM drive’s mounting holes with the mounting holes on the drive rails and secure with four screws (two on each side).
4.Slide the back-panel connector assembly back into the end groove guide.
5.Place the top cover over the drive assembly, making sure the end-panel assembly slides into its end groove guide.
Top Cover
Mounting
Screws (x4)
End-Panel
Assembly
Drive
Mounting
Screws (x4)
Top Cover
Rubber
Stands (x4)
CD-ROM
Drive
Bottom
Cover
Installing Covers and Rubber Stands
4 | CD-ROM Box Enclosure Installation Guide |
