VIPowER VPM-6248T user manual LED Indicators, Mounting a 3.5-inch Drive in the MobileRACK

Page 10

2-3 LED Indicators

Red and green indicators are located on the front panel of the VPM-6248T External Enclosure. The green LED is lit when the power is ON. The red activity LED will flash when a HDD installed in the MobileRACK is being accessed.

	MobileRACK
	LED Indicators
	MobileRACK
	Latch-Lock
	VPM-6248T
	LED Indicators
Green LED	Red LED
(Power)	(HDD Access)

VPM-6248T Front Panel with the MobileRACK

2-4 Mounting a 3.5-inch Drive in the MobileRACK

The VPM-6248T External Enclosure is factory configured with the MobileRACK already installed.

Although these instructions specify a hard disk installation, the steps are typical for mounting any device in the MobileRACK drive case.

Step 1.

Separate the MobileRACK drive tray from the drive case installed in the VPM-6248T External Enclosure by lifting the handle and pulling the drive tray out.

Remove the

MobileRACK

Drive Tray

Remove the MobileRACK Drive Tray

10	VPM-6248T USER MANUAL

Image 10

Contents VPM-6248T Proprietary Notice Contents Introduction Features and SpecificationsVPM-6248T External Enclosure MobileRACK Operating SystemsPackage Checklist Package ContentsTemperature Control Jumper Settings Hardware InstallationRemove Mounting Screws to Remove Cover Temperature Control Jumper Locations Configuration with the MobileRACK Factory Configuration with MobileRACKVPM-6248T Front Panel with the MobileRACK LED IndicatorsMounting a 3.5-inch Drive in the MobileRACK Remove the MobileRACK Drive TrayRemove the MobileRACK Drive Tray Cover Remove Front Panel for Removable Media DrivesMobileRACK Drive Tray with Cover Removed Mount the Drive in the MobileRACK Drive TrayComputer Requirements Connecting the VPM-6248T to a ComputerReplace the MobileRACK Drive Tray Cover Insert Drive Tray into VPM-6248T EnclosureSlide the Latch-switch Left to Lock VPM-6248T External Connector Locations VPM-6248T ConnectionsDriver Installation Windows 98SEStep Select Win98 under the Drivers directory, then click OK Click Next Step Windows Me/2000/XP Mac OS Using the VPM-6248T External Enclosure Connecting the VPM-6248T to ComputerWindows Disconnecting the VPM-6248T from ComputerWindows Me/2000/XP Latch-lock Switch Positions Using the MobileRACK Drive TrayMac OS Partitioning Under Windows 98/ME Partitioning the External USB 2.0 Hard DiskMethod At the DOS prompt, type Fdisk and press Enter Step Partitioning under Windows 2000/XP Step Step Printed on recycled paper