VIPowER VPM-6248T Configuration with the MobileRACK, Factory Configuration with MobileRACK

2-2 Configuration with the MobileRACK

The following information is for reference only. The VPM-6248T is factory configured with the MobileRACK docking case installed with these settings.

Jumper JP6, and CN6 with a 2-wire red-black cable connector, are located on the rear PCB panel of the enclosure. These enable operation of the MobileRACK with the VPM-6248T enclosure.

The default jumper setting for JP6: pins 2-3 ON.

			JP8
			Temperature
			Control Jumper
Power		Power	USB
Switch		Conn.	Port
			LED
			Fan
JP6			Power
CN6		JP7	40-Pin IDE Data
			Connector
		Temperature
2-pin
		Control
Red-Black Cable		Jumper
3	JP6 (2-3 ON) & CN6 : configuration with
2	MobileRACK (factory default setting)
1

Factory Configuration with MobileRACK

VPM-6248T USER MANUAL 9