Whistler 1200 WATT, 2000 WATT, 3000 WATT Important Information on Battery Chargers, Power Source

Page 11

OPERATION

Check frequently to ensure that the input and output connections are secure. Loose connections may damage the inverter, the power source, or may generate excessive heat.

The following precautions apply to the 3000 watt models only.

a). The AC receptacles are equipped with 15 amp circuit breakers. Consequently, each of these outlets is rated for a maximum output of 1500 watts (110 volts x 15 amps).

To generate the maximum output, the 3000 watt model should be connected to a power supply which has the capacity to produce up to 300 amps. The loads should be distributed between the two receptacles to ensure that each outlet is producing no more than its maximum 1500 watt output.

If more than one piece of equipment or appliance is to be operated at the same time, first turn on the inverter and then turn on each piece of equipment or appliance separately to enable the inverter to produce the required start up loads.

Important Information on Battery Chargers

Using your inverter to recharge units designed to charge such portable equipment as power tools, flashlights, video cameras and laptop computers may cause damage to the inverter

OPERATION

or the charging unit. Check with the appliance manufacturer for compatibility with sine wave inverters if you’re unsure.

Although we advise against it, if you attempt to recharge a charging unit, monitor the temperature of the charging unit for approximately 10 minutes. If the charging unit becomes unusually warm, disconnect it from the inverter immediately.

The Power Source.

When the engine is off, most batteries will provide ample power supply to the inverter for one to two hours. The actual length of time is a function of several variables including the age and condition of the battery, the number of batteries and the power demand being placed on it by the equipment being operated with the inverter. If you are using the inverter while the engine is off, we recommend you start the engine every 30 to 60 minutes and let it run for at least 10 minutes to recharge the battery. We also recommend that the device plugged into the inverter be turned off before turning over the engine.

Although it is not necessary to turn off the inverter when turning over the engine, the inverter may momentarily cease operation as the battery voltage decreases. When the inverter is not supplying power, and turned on, it draws low amperage from the battery (<0.65 A ).

For You Television Fans & Audiophiles.

Although the inverter is shielded and filtered to minimize signal interference, some interference with your television picture

18

19

Image 11
Contents Watt Series Introduction Hours Monday Friday Am 500 pm CTWhistler Features Table of ContentsWattage & Voltage FeaturesRemote Operation Jack Standard North American 110 AC Outlets are provided Getting Started Important InformationInverter Information Don’t Push It Selecting the Optimum Power Source1200 Battery InformationBATTERY/CABLE Information Wire Cable GaugesMaking the Connection Cable InformationOperation 2000This ground can’t be the same ground as the AC ground For You Television Fans & Audiophiles Important Information on Battery ChargersPower Source For You Microwave Chefs Some Powerful Advice Modified sine wave produced by Your Whistler Inverter Operating PrincipalsFor You Technical Types True sine wave typical of home AC outlet Review Operating PRINCIPALS/SUMMARYOperation Summary Troubleshooting Overload or High Temp LED on Problem Solution SpecificationService Out Of Warranty WarrantyConsumer Warranty Service Under WarrantyCustomer Service Warranty Memo