CABLE INFORMATION
Adapter." Use of #0 gauge wire to make the connections to the inverter may require a "0 to 4 Gauge Adapter." Both adapters are available through electronic supply stores including Radio Shack. Radio Shack part number is listed below:
O Ring Adapter: | RSU11538139 |
0 to 4 Gauge Adapter: | RSU11538667 |
2000 and 3000
When the inverter and the battery are set up within four feet
of each other, use a minimum of #2 gauge wire to make the connections. Within four to six feet, use two #0 gauge wire. At distances of more than six feet, use #0 gauge wires connected in parallel to the battery.
OPERATION
Making the Connection.
1.Make certain that the Power switch is in the OFF (O) position.
2.Connect the cables to the power input terminals at the rear of the inverter and tighten the screws to make a secure connection. Do not use tools to tighten these screws.
(To make these connections on the 2000 and 3000, remove the supplied nut at each terminal on the inverter, install the wire connectors flush with the metal backing plates and refasten the nuts securely.
3.Connect the cable from the Negative
4.Confirm that the cable you have just installed is properly connected. Specifically, make certain that the cable is connected to the Negative
5.Connect the cable from the Positive (+) terminal on the inverter to the Positive (+) terminal on the power source.
14 | 15 |