Whistler 3000 WATT, 2000 WATT Specification, Overload or High Temp LED on Problem Solution

Page 16

TROUBLESHOOTING

Overload or High Temp LED on

Problem

Solution

Equipment has a high

Turn inverter power switch

start up surge.

OFF (O) and then ON (l)

 

again until the inverter

 

powers your appliance.

 

Repeat as necessary

 

to get your appliance

 

"started".

Battery voltage below

Recharge or replace

10 volts.

battery.

Equipment being operated

Use a higher capacity

draws too much power.

inverter or do not use this

 

equipment.

Inverter is too hot (thermal

Allow inverter to cool.

shutdown mode).

Check for adequate

 

ventilation. Reduce the

 

load on the inverter to

 

rated continuous power

 

output.

SPECIFICATION

WHISTLER 1200 WATT INVERTER SPECIFICATIONS Maximum Continuous Power……………………………1200 Watts

Maximum Surge Capability (Peak Power)

.......................2400 Watts

No Load Current Draw………………………………...............0.50 A

Waveform……………………………….............Modified Sine Wave

Operating Input Voltage Range…………….............10-15 Volts DC

AC Receptacle……………………..............Dual 3 Prong Grounded

Approximate Dimensions

9.5” L x 8.5” W x 3” H

Approximate Weight………………...................………………..8 lbs

WHISTLER 2000 WATT

INVERTER SPECIFICATIONS

Maximum Continuous Power…………........................…2000 Watts

Maximum Surge Capability (Peak Power).......................4000 Watts

No Load Current Draw…………………………...............…....0.50 A

Waveform…………………………...............…..Modified Sine Wave

Operating Input Voltage Range………….................10-15 Volts DC

AC Receptacle…………………..................Dual 3 Prong Grounded

Approximate Dimensions….........................13” L x 10.5” W x 3” H

Approximate Weight………………..............………………….12 lbs

WHISTLER 3000 WATT

INVERTER SPECIFICATIONS

Maximum Continuous Power……………........................3000 Watts

Maximum Surge Capability (Peak Power).......................5000 Watts

No Load Current Draw……………………………...............…0.80 A

Waveform…………………………….................Modified Sine Wave

Operating Input Voltage Range………….............…10-15 Volts DC

AC Receptacle……………………..............Dual 3 Prong Grounded

Approximate Dimensions…….................... 16” L x 9” W x 6.25” H

Approximate Weight……………………....…………….............20 lb

28

29

Image 16
Contents Watt Series Hours Monday Friday Am 500 pm CT IntroductionTable of Contents Whistler FeaturesRemote Operation Jack FeaturesWattage & Voltage Standard North American 110 AC Outlets are provided Inverter Information Important InformationGetting Started Selecting the Optimum Power Source Don’t Push ItBattery Information BATTERY/CABLE InformationWire Cable Gauges 1200Cable Information Operation2000 Making the ConnectionThis ground can’t be the same ground as the AC ground Power Source Important Information on Battery ChargersFor You Television Fans & Audiophiles For You Microwave Chefs Some Powerful Advice For You Technical Types Operating PrincipalsModified sine wave produced by Your Whistler Inverter Operation Summary Operating PRINCIPALS/SUMMARYTrue sine wave typical of home AC outlet Review Troubleshooting Specification Overload or High Temp LED on Problem SolutionWarranty Consumer WarrantyService Under Warranty Service Out Of WarrantyWarranty Memo Customer Service