XiNCOM XC-DPG503 manual Multi DMZ & UPnP, For Dynamic IP, Select the desired WAN port

Settings - Multi DMZ

Enable

Use this to enable or disable the DMZ setting when required.

Name

Enter a name to assist you to remember this setting. This name has no effect on the operation.

For Static IP

Public IP Address

Enter the WAN port (Internet) IP address you wish to associate to a PC. This IP address must have been allocated to you by your ISP.

Private IP Address

Enter the IP address of the PC you wish to associate with this WAN port IP address. This IP address should be fixed, or reserved.

(LAN)

(See the Host IP section for details on reserving an IP address.)

For Dynamic IP

WAN

Select the desired WAN port.

Session

• Select “DHCP” if the IP address on this WAN port is dynamically assigned. You can only select assign one (1) Private (LAN) IP

address to each port.

• If using multi-session PPPoE, select the desired PPPoE session. These sessions are defined on the Advanced PPPoE screen. You

can assign one (1) Private (LAN) IP address to each PPPoE session.

Private IP Address

Enter the IP address of the PC you wish to associate with this WAN port IP address. This IP address should be fixed or reserved. (See

(LAN)

the Host IP section for details on reserving an IP address)

Access Group

You can decide the users to have the authority of using DMZ by defining the groups.

Direction

For DMZ, you can allow inbound, outbound only, or both inbound and outbound.