Using the Hold Feature
When an item being weighed extends over the front of the scale and you cannot see the display, you can freeze the display so that the weight is still displayed after removing the item.
To use the Hold feature
1.Press HOLD .
The display shows HOLD and then 0.0 when ready.
2.Place the item on the scale.
3.After a few seconds, remove the item from the scale.
The weight continues to be displayed for about ten seconds.
4.Press HOLD to deactivate the hold feature.
Changing the Units of Measure
Your scale can display weight in English (pounds) or metric (kilograms) units. The default unit of measure is English. Each time you turn on the scale, the scale defaults to the unit of measure that was last used.
To change the units of measure
♦Press
kg | lb |
to toggle between English and metric units.
Mounting the Display
The scale features a detachable display. The display can be mounted to most metallic surfaces using the
To mount the display to a non-metallic surface
1.Drill two holes 4 3/4 inch (120 mm) apart at the desired height on the wall using the template at the back of this User Guide.
2.Screw one screw into each of the holes until the screw head sticks out from the wall 1/8 inch (3 mm).
!Allowing the screw heads to stick out farther than 1/8 inch (3 mm) may damage the scale display.
3.Align the holes on the back of the scale display with the screws.
4.Slide the display onto the screws.
The display should slide onto the screws firmly and securely.
4