3M 800r3 manual Tape Threading Label, Knife Warning Label

Important Safeguards (Continued)

The following two labels are located on the upper and lower taping heads. Replacement part numbers for these labels are listed below each label.

The "Warning-Sharp Knife" label warns operators and service personnel of the extremely sharp knife used to cut the tape at the end of the box sealing operation. The label, shown in Figure 1-11, is located on the orange knife guard between the applying roller assembly and the buffing roller assembly. Never operate taping heads with knife guard removed.

Before working with the taping heads or loading/ threading tape, refer to Figures 3-1 and 3-2 in Section II to identify the knife location. Keep hands out of these areas except as necessary to service the upper taping heads or to load/thread tape.

The "Tape Threading Label", shown in

Figure 1-12,is attached to the left side of both the upper and lower taping heads. This label provides a convenient tape threading diagram. More detailed tape loading and threading information is provided in this manual in the set-up procedure section.

Figure 1-12 – Tape Threading Label

Figure 1-11 – Knife Warning Label

6