Zebra Technologies LP 2844 manual Printing in Peel-Mode

Page 29

Printing in Peel-Mode

ON

OFF

The optional dispenser allows you to print in “peel-mode” where the

label backing follows a different path and the labels are presented one at a time for subsequent placement.

1.Remove several labels from the backing material.

2.Open the top cover.

3.Open the dispenser door.

4.	Switch on the label-taken sensor.
5.	Insert the backing in front of the peel
	bar and behind the peel roller.
6.	Close the dispenser door.
7.	Close the top cover.
8.	Press the Feed button to advance the
	label.
During the print job, the printer will peel
off the backing and present a single label.
Take the label from the printer so it will
print the next label.
	MOVIE
980483-001A	21

Image 29

Contents Zebra LP 2844TM Desktop Printer 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Hello IntroductionWhats in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Placing the Roll in the Media Compartment Loading Roll MediaAdjusting the Guides Operator Controls Power SwitchFeed Button Status LightMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerParallel Interface Requirements USB Interface RequirementsEthernet Interface Requirements Serial Interface RequirementsUniversal Serial Bus USB Communications Communicating with the PrinterParallel Communications Internal ZebraNet PrintServer II CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print Width 980483-001A Thermal Printing Operation & OptionsReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Cleaning MaintenanceMedia Path Considerations Cleaning Card ConsiderationsPrint Head Considerations Platen Considerations LubricationRemoval AssemblyReplacing the Platen Replacing the Print Head Removal Direct-Thermal LP ModelAssembly 980483-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Print head is under temperature Print Quality ProblemsNo print on the label Printed image does not look rightLabel format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesInterfaces Universal Serial Bus USB ConnectorAppendix Host Parallel InterfaceZebraNet PrintServer II Internal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector

Related manuals

Manual 54 pages 4.94 Kb