Zebra Technologies LP 2844 manual Using the Cutter Option

Page 31

Using the Cutter Option

Printers that have a bezel with a motorized blade can dispense one or more forms that are then automatically cut from the media supply. This option cuts through continuous paper from rolls and liner between labels. Keep the cutter dry. Never use any solutions or solvents to clean the blade.

Use the f command to set the cut position and the C command to cut immediately outside a form.

If the blade cuts through labels, adhesive can jam the cutter.

1. Turn OFF (O) printer power and unplug the power and interface cables before clearing the cutter.

2. After removing debris, plug in the power and interface cables, turn on the printer, then test for normal operation.

980483-001A

23

Image 31
Contents Zebra LP 2844TM Desktop Printer 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Hello IntroductionWhats in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Placing the Roll in the Media Compartment Loading Roll MediaAdjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerSerial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface RequirementsInternal ZebraNet PrintServer II Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print Width980483-001A Thermal Printing Operation & OptionsReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Cleaning MaintenancePrint Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Platen Considerations LubricationReplacing the Platen AssemblyRemoval Replacing the Print Head Removal Direct-Thermal LP ModelAssembly 980483-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Printed image does not look right Print Quality ProblemsPrint head is under temperature No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesAppendix Universal Serial Bus USB ConnectorInterfaces Host Parallel InterfaceZebraNet PrintServer II Internal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector
Related manuals
Manual 54 pages 4.94 Kb