Zebra Technologies LP 2844 manual Media Handling

Page 43

			Media Handling
			Media Handling

	Problem		Solution or Reason

			Label Dispenser

		1. Make sure label-taken sensor is on.
		2. The label-taken sensor is blocked or dirty. Remove any
	Printing continues		scraps or dust.
	between labels.	3.	Continuous media may be set. Verify form length setting
			through programming Q command. See the programming
			guide.

	Prints one label and	1. Verify the quantity has been correctly set.
	then stops.	1. Verify the quantity has been correctly set.
	then stops.

			Cutter Operation

	Blade cuts through
	labels instead of	1. Verify form length setting through programming
	cutting liner between	1. Verify form length setting through programming
	cutting liner between
	labels.

	Media jammed in	1.	Unplug power and interface cables. Use tweezers to
	cutter.		remove scaps from cutter opening.

	Blade fails to cut	1.	Use programming C command to cycle cutter several times
	Blade fails to cut		without media to perform a self-cleaning. See the
	direct thermal paper		without media to perform a self-cleaning. See the
	direct thermal paper		programming guide.
	or label liner.		programming guide.
	or label liner.	2.	Cutter must be replaced.
		2.	Cutter must be replaced.

980483-001A

35

Image 43

Contents Zebra LP 2844TM Desktop Printer 980483-001A Proprietary Statement Shock Hazard Contents Operation & Options 980483-001A Vii 980483-001A Hello IntroductionWhats in the Box? Opening the printer Inspecting the PrinterInspecting the Printer Closing the printer Reporting Damage Related DocumentationModes of Printing Getting StartedAttaching Power Supply Placing the Roll in the Media Compartment Loading Roll MediaAdjusting the Guides Status Light Power SwitchOperator Controls Feed ButtonMedia Length Sensing Interface Cable Requirements Hooking Up the Printer and ComputerSerial Interface Requirements USB Interface RequirementsParallel Interface Requirements Ethernet Interface RequirementsInternal ZebraNet PrintServer II Communications Communicating with the PrinterUniversal Serial Bus USB Communications Parallel CommunicationsSerial Communications CommandAdjusting the Print Quality Adjusting the Print Width980483-001A Thermal Printing Operation & OptionsReplacing Supplies Printing in Peel-Mode Printing on Fan-Fold Media Using the Cutter Option 980483-001A Cleaning MaintenancePrint Head Considerations Cleaning Card ConsiderationsMedia Path Considerations Platen Considerations LubricationReplacing the Platen AssemblyRemoval Replacing the Print Head Removal Direct-Thermal LP ModelAssembly 980483-001A What the Status Light is Telling You TroubleshootingPrinter Operation Media Handling Printed image does not look right Print Quality ProblemsPrint head is under temperature No print on the labelLabel format was sent to, but not recognized by, the printer Manual Calibration Communications Diagnostics Resetting the Factory Default ValuesPrinter Condition Feed Button Action Feed Button ModesAppendix Universal Serial Bus USB ConnectorInterfaces Host Parallel InterfaceZebraNet PrintServer II Internal Ethernet PrintServer Looking into the Printer’s RJ-45 Modular ConnectorSerial RS-232 Connector

Related manuals

Manual 54 pages 4.94 Kb