Panasonic AW-DU600 Receiving system connection procedure, N u j 1 F u n c t i o n R x D i r e c t

Connections

Receiving system connection procedure

1.Connect the AW-PS301 AC adapter to the DC 12V IN connector on this adapter.

2.Connect the TO MODEM connector to the RS-232C connector on the modem using the RS-232C cable provided with the modem.

3.Connect the telephone line to the line input jack on the modem.

4.Connect the pan-tilt head to this adapter.

O If the connection distance between this adapter and the AW-PH300A pan-tilt-head is 10 m or less, use the AW-CA28T9 (10 m) cable to connect the RS- 232C CONTROL OUT connector on this adapter to the P/T CONTROL IN connector on the AW-PH300A.

O If the connection distance between this adapter and the AW-PH300A pan-tilt-head is more than 10 m, use an RS-232C/RS-422 converter between the RS-422 CONTROL OUT connector on this adapter to the P/T CONTROL IN connector on the AW-PH300A when performing the connection.

O When the AW-PH350 pan-tilt-head is used, use a 10 BASE-T cable to connect the RS-422 CONTROL OUT connector on this adapter to the CONTROL IN IP/RP connector on the AW-PH350.

When an AW-RP301 or AW-RP501 is used as the controller, connect the pan-tilt head to the P1 CONTROL OUT connector on this adapter.

5.Set the power switch on the AW-DU600 to ON.

6.Dial Up Adapter settings

1 Set this adapter to receive mode.

Press the MENU+ key ( 2 i START ) to open the menu settings.

When “Menu-1 Function” appears on the LCD panel,

use the !			# keys and select
	START	STOP
Rx (receive mode).

M e n u j 1 F u n c t i o n

T x R x D i r e c t

2Select the pan-tilt head system control.

Press the MENU+ key ( 2 i START ) to change the menu setting item.

When “Menu-5 Output-1” appears on the LCD panel,

use the !			# keys and select
	START	STOP
RS-2332C or RS-422 according to operating
conditions.

M e n u j 5 O u t p u t j 1

R S j 2 3 2 C R S j 4 2 2

When the settings are completed, press the				MENU+
key ( 2 i		) once again to exit	the menu
	START
settings.

7.Set the power switch on the modem and the pan-tilt head to ON.

8.“OK” appears on the LCD panel.

M o d e :	R e c e i v e r
O K

If the modem is not connected correctly, [---] will appear on the LCD panel.

M o d e : R e c e i v e r

j j j

11