Panasonic AW-DU600 RS-422 Control OUT connectors P1 to P5, To Modem connector, = GND connector

Parts and their functions

$ Rear panel

6

RS-232C CONTROL OUT

TO CAMERA & PAN/TILT HEAD

P5	P4	P3	P2	P1
		RS-422 CONTROL OUT
	TO CAMERA & PAN/TILT HEAD
P5	P4	P3	P2	P1
		OUT PUT

7

6RS-232C CONTROL OUT connectors (P1 to P5) These connectors are used to connect the pan-tilt head system controlled with RS-232C.

<Note>

These connectors cannot be used in conjunction with the RS-422 CONTROL OUT connectors 7.

7RS-422 CONTROL OUT connectors (P1 to P5)

These connectors are used to connect the pan-tilt head system controlled with RS-422.

<Note>

These connectors cannot be used in conjunction with the RS-232C CONTROL OUT connectors 6.

8TO MODEM connector

This is used to connect the modem.

Connect this connector to the RS-232C connector on the modem using the RS-232C cable provided with the modem.

9TO RCB/PC connector

This is used to connect the WV-CB700A RCB (remote control box). When the RCB is connected, the control signals input to the CAMERA CONTROL IN connector < are disabled.

If the WV-CB700A is connected to the control panel (AW- RP301, AW-RP501 or AW-RP505), operation of the IRIS control on the control panel takes precedence.

Also, if a PC is connected when the adapter is in direct mode, it is possible to control a pan-tilt head system.

89

TO MODEM		INPUT
		TO RCB/PC
		DC 12V IN
TO CONTROL PANEL			>
	A		?
	B	GND
PAN/TILT		CAMERA
CONTROL IN		CONTROL IN

:; < =

:PAN/TILT CONTROL IN connector This is used to connect the controller.

When an AW-RP301, AW-RP501 or AW-RP505 is being used, connect it to the PAN/TILT CONTROL OUT connector.

When an AW-RP605 is being used, connect it to the EXTERNAL CONTROL OUT connector on the main unit.

<Note>

An AW-RP605 cannot be used for control in direct mode.

;Control panel selector switch

This is switched according to the control panel connected.

A:AW-RP605

B:AW-RP301,AW-RP501,AW-RP505, and WV-CB700A

<CAMERA CONTROL IN connector

When an AW-RP501 or AW-RP505 is being used as the controller, connect it to the CAMERA CONTROL OUT connector on the control panel.

=GND connector

This is connected to the GND earth to prevent malfunction caused by external noise.

>DC 12V IN connector

This is the power input connector and is used to connect the AW-PS301.

?Cable clamp

This is provided for the AW-PS301 cable to prevent the cable from being pulled out.

5