Panasonic CF-73 Series appendix Battery Indicator, Touch Pad / Touchscreen

Page 28

Dealing with Problems (Summary)

Battery Indicator

The red indicator lights	The battery level is very low (the charge is approx. 9% or less).
	Connect the AC adaptor. You can use the computer when the battery indicator light is
	orange. If you do not have an AC adaptor, save your data and power off your computer.
	After replacing the battery pack with a fully charged one, turn your computer on.
The red indicator blinks	Quickly save your data and power off your computer. Remove the battery pack and dis-
	connect the AC adaptor, then connect them again.
	If the problem persists, contact Panasonic Technical Support. The battery pack or charg-
	ing circuit may be defective.
The green indicator blinks*1	In high temperature mode, the battery is discharging to the level that corresponds to an
	80%*2 charge for normal temperature mode. (			“Battery Power”) Do not re-

	move the battery pack while the battery indicator is blinking green. If you remove it, the
	power will be turned off forcibly.
	*1 Only for the main battery pack.
	*2 In high temperature mode, the level that corresponds to an 80% charge for normal tem-
	perature mode is displayed as [100%].
The orange indicator blinks	Battery cannot be recharged temporarily because the internal temperature of the battery
	pack is outside of the acceptable temperature range for recharging. Once the allowable
	range requirement is satisfied, charging begins automatically. Your computer can be used
	normally in this state.

Touch Pad / Touchscreen

The cursor cannot be con-	If you are using an external mouse, ensure that the external mouse has been connected
trolled properly	correctly.
	Restart the computer by using the keyboard.
	(Press				, U , and select [Restart] with R )
	If the computer does not respond to keyboard commands, read “No response”
	(			page 29).

Unable to input using the	Has the Setup Utility been used to set [Touch Pad] to [Enable]?
touch pad	When external mouse drivers are installed (e.g., IntelliMouse), the touch pad may not be
	used.
	Has the touch pad driver been properly installed?
Unable to point correctly	As a result of the physical characteristics of the touchscreen, sometimes the position of the
with the stylus included with	stylus does not match the position of the cursor on the screen. This is not a malfunction.
the computer	Perform [Calibration]. (						page 14)

Troubleshooting

Reference Manual

The Reference Manual is	Is Adobe Reader installed?
not displayed	If you have uninstalled Adobe Reader, install using the following procedures.

1Log on to Windows with the administrator authority.

2Select [start] - [Run], input [c:\util\reader\AdbeRdr70_enu_full.exe], then select [OK]. Install Adobe Reader by following the instructions on the screen.

Reinstalling B’s Recorder/B’s CLiP

When reinstalling, the input	Input the following serial number
of a serial number has been	B’s Recorder:
asked	B’s CLiP:

28

Image 28

Contents Operating Instructions Introduction Illustrations and Terminology in this ManualCopyright Disclaimer Trademarks EnterRead Me First For U.S.AFCC Regulation Notice for modem This equipment contains a FCC approved modemFor Canada Read Me FirstIndustry Canada IC Notice for modem For Europe Industry CanadaRF Exposure Warning For models with a CE mark on the bottom of the computerLithium Battery Information to the UserCD/DVD Drive Caution PrecautionsUsage Precautions Battery Pack Names and Functions of Parts Names and Functions of Parts Turn the computer over and insert the battery pack First-time OperationConfirm the inclusion of all parts Read the Limited USE License AgreementConnect your computer to a power outlet Setup WindowsFirst-time Operation Open the displayCreate a new account When creating a new user accountSecurity Center Resetting the password Information for Windows XPCalibrate the touchscreen This concludes the first-time use operation guidelinesLatch Power Indicator Power Switch Starting Up/Shutting DownStarting Up Situation ActionSetup Utility Starting Up/Shutting DownLog on to Windows Select your applicationShutting Down power off your computer To shut down using the keyboardWhen you leave the computer or interrupt your work To quickly resume computer operation after shutting downTouch Pad Work Surface Right Button Left ButtonFunction Operation Moving the Cursor Tapping/Clicking Tapping clickingReference Manual Reference Manual / Important TipsReference Manual Important TipsMaintenance Useful InformationUsage Environment HandlingSecurity Center/Antivirus Protection What is Windows Security Center?Areas excluding the display Windows Update Useful InformationComputer Viruses Saving Data on the Hard DiskWhen Using Peripheral Devices When Changing Hard Disk PartitionsWhen Disposing of or Transferring Ownership of This Device Wireless LAN only for models with wireless LANTo run the Setup Utility List of Error CodesError Code/Message Dealing with Problems Summary Starting UpDealing with Problems Summary Entering PasswordDisplay NumLkShutting Down Reinstalling B’s Recorder/B’s CLiP Battery IndicatorTouch Pad / Touchscreen SD Memory Card Fast User Switching FunctionOthers Reinstalling Software Before ReinstallationReinstalling PreparingIf the following message appears, press R Changing the drive letterAbout Intel software products Etary rights in the productLicence Contrat de licence d’usage limitéTermes, clauses et conditions Before Using a Hard Disk Backup Function Hard Disk Backup FunctionPreparing Create a Backup Area Backing Up and Restoring Data Hard Disk Backup FunctionAt the confirmation message, select Yes and press Enter To disable the hard disk backup function Procedure Hard Disk Data Erase UtilitySpecifications Main SpecificationsSpecifications Wireless LAN only for models with wireless LANSoftware Operating SystemLimited Warranty Panasonic Computer and Peripherals Limited Warranty Panasonic Computer Solutions Company Panasonic Canada Inc