If the following message appears, press R .
Computer must be rebooted in order to execute [Recovery].
Please reboot with Product Recovery
After rebooting, execute [Recovery] following the on screen instructions.
10 At the confirmation message, press Y .
The operation of reinstallation for the hard disk starts au- tomatically. (The operations take about 20 minutes.)
CAUTION
Do not interrupt the reinstallation procedure be- fore completion, for example by turning off the computer or pressing Ctrl + Alt + Del , as this may prevent Windows from starting up, or may cause data to be lost so that the reinstallation pro- cedure cannot be executed.
After the reinstallation procedure completes, this screen should appear.
[Recovery] is complete.
Windows(R) XP Professional install wizard will start after reboot.
Please remove the Product Recovery
11Remove the Product Recovery
The computer will be shut down.
12Turn on the computer, and press F2 while [Panasonic] boot screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Pass- word.
13Press F9 .
At the confirmation message, select [Yes] and press Enter . (The Setup Utility settings will return to their
default values. Even the security settings with the excep- tion of the password(s) will return to their default values.)
14Select [Exit] and then select [Save Current Values], then press Enter .
At the confirmation message, select [Yes] and press
Enter .
15Turn off the computer by pressing the power switch.
NOTE
If additional instructions are included with the com- puter, be sure to read them. It may be necessary to perform additional operations during the following procedures.
16 Perform the |
| page 12 step 6 |
| ||
- page 14 step 9 ). |
|
|
17Run the Setup Utility and change the settings where nec- essary.
<Changing the drive letter>
You can change the drive letter for the CD/DVD drive or hard disk drive by the following steps.
Drive letters can only be changed when two or more parti- tions have been created on the hard disk drive. The drive letter of the C drive cannot be changed.
We recommend that you make these changes before in- stalling applications.
1Select [start] - [Control Panel] - [Performance and Mainte- nance] - [Administrative Tools] - [Computer Management].
2Select [Disk Management] from [Storage].
3Right click on the partition of the hard disk or the name of the CD/DVD drive and select [Change Drive Letter and Paths...].
4Select [Change].
5Select [Assign the following drive letter] and select the new drive letter, and then select [OK].
6At the confirmation message, select [Yes].
Troubleshooting |
31