Panasonic CF-U1GQGTG2M appendix If the computer’s power supply is dis

Starting Up

[Enter Password]
does not appear		The password you have set in the Setup Utility is not
when resuming from		requested at resuming. To use the password security at
sleep		resuming, set the Windows password.
(	) /	A Click	(Start) - [Control Panel] - [User Accounts
standby		and Family Safety] - [Add or remove user accounts]
(	) or	and select the account, and set the password.
hibernation.		B Click	(Start) - [Control Panel] - [System and
		Security] - [Power Option] - [Require a password
		when the computer wakes] and add a check mark
		for [Require a password].
		Set the Windows password. The password you have
		set in the Setup Utility is not requested at resuming.

AClick [start] - [Control Panel] - [User Accounts] and select the account, and set the password.

BClick [start] - [Control Panel] - [Performance and Maintenance] - [Power Options] - [Advanced] and add a check mark for [Prompt for password when computer resumes from standby].

Cannot resume.	An error may occur when the computer automatically
	enters the sleep (		) / standby
	(	) or hibernation mode while the screen-
	saver is active. In this case, turn off the screensaver or
	change the pattern of the screensaver.
	If you press and hold the power switch for 4 seconds or
	longer, the power will be turned off forcibly and the
	computer will not resume. In this case, all unsaved data
	will be lost.
	You disconnected the AC adaptor and the battery pack
	while the computer was in sleep (			) / standby
	(	). If the computer’s power supply is dis-
	connected in sleep (			) / standby
	(	), unsaved data will be lost and the com-
	puter will not resume.
	The battery is exhausted. Sleep (			) / stand-
	by (	) and hibernation consume some
	power.

Troubleshooting

41