Panasonic CF-74JCJBD1 M Removing the Touch PAD and PAD PCB, Removing the Finger PCB, Preparation

1.Disconnect the LCD/INV. Cable from the Connector on the Inverter.

2.Remove the LCD Unit.

3.Remove the Inverter with the Inverter Case.

4.Remove the two Screws <N18>, and then the W-LAN PCB L and R.

Screws <N18>: XQN17+BJ6FJ

9.1.19.Removing the Touch PAD and PAD PCB

Palm Rest Sheet

Pad WP Sheet A

<N20>

<N20>

<N20><N20>

PAD Base Ass’y

PAD Button

WP Rubber

		Touch PAD
PAD SW PCB
		CN1302
<N14>	<N14>	CN1301
<N14>
		Sheet

1.Remove the Palm Rest Sheet.

2.Remove the four Screws <N20>, and then PAD Base Ass'y.

3.Disconnect the two Cables from the two Connectors (CN1301, CN1302).

4.Remove the three Screws <N14>.

5.Remove the PAD Button WP Rubber and PAD SW PCB.

6.Remove the Touch PAD.

Screws <N14>: DRHM0106ZA

Screws <N20>: DXQT2+G4FCL

9.1.20. Removing the Finger PCB

Finger PCB	<N9>
	<N9>

<N9>

FP FFC Cable Finger Sensor Base

Preparation

Perform the steps up to removing of the Main PCB.

1.Remove the three Screws. <N9>

2.Remove the Finger PCB and Finger Sensor Base.

Screws <N9>: DFHE5025XA

9-7