Panasonic CF-74JCJBD1 M service manual Setting the PC Card Ejector and Lithium Battery

9.2.10. Setting the PC Card Ejector and Lithium Battery

1.Attach the Lithium Battery to the Main PCB.

2.Pass the Lead Wire of the Lithium Battery through the groove of the Main PCB, and connect it to the Connector (CN14) on the back side.

3.Fix the PC Card Ejector to the Main PCB using the two Screws<N9>.

Screws <N9>: DFHE5025XA

Lithium Battery	PC Card Ejector
(to CN14)

CN14

Main PCB

<N9>

Arranging the Lithium Battery

Safety Working S2

Pass the Cable through the groove of the Main PCB.

Match the end of the Tape. (0 to 1 mm)

Tape

Main PCB

Connect to the Connector (CN14) on the back side.

Match the end of the Tape. (0 to 1 mm)

Fix the Cable using the Tape.

Pass the Cable between the parts. (Avoid running over the parts.)

Lithium Battery

9.2.11.Setting the Main PCB

Note:

After replacing the Main Board, rewrite the BIOS ID.

1.Set the MP Guide to the Main PCB.

2.Set the Main PCB to the computer.

3.Fix the Main PCB using the six Screws<N9>.

4.Connect the ten Cables to the corresponding Connecters (CN6, CN7, CN24, CN19, CN28, CN21, CN802, CN18, CN15, CN25).

Screws <N9>: DFHE5025XA

<N9>	CN21
CN6	CN802
	CN18
Main PCB	CN15

CN7

CN24

CN28<N9>

CN19

MP Guide

CN26

9-18