Panasonic CF-74JCJBD1 M service manual Setting the Keyboard, Center Cover

9.2.16. Setting the Keyboard

1.Connect the KBD FPC Cable to the Connector (CN25) of the Main PCB.

2.Connect the two Cables of the Keyboard to the two Con- nectors on the KBD FPC.

3.Remove the Release Paper of the KBD WP Sheet, and attach the KBD WP Sheet to the computer as it covers the Cable of the Keyboard.

Note:

Press strongly enough until the color of the contact of two-sided tape is changed.

KBD WP Sheet

Connectors

Connector (CN25)

KBD FPC

4.Insert the front Hooks of the Keyboard and the FPC to the computer, and set the Keyboard to the computer.

5.Fix the KBD Angle L and R using the four Screws<N9>.

6.Hook the six front Hooks of the Center Cover to the KBD Angle L and R.

7.Hook the seven rear Hooks of the Center Cover to the computer, and press the Center Cover to be securely set in.

Screws <N9>: DFHE5025XA

Center Cover Hooks

Hooks

<N9>

KBD Angle L

<N9>

Keyboard KBD Angle R

Cautions for Setting the Center Cover

Center Cover

Hook with the front hooks. (six points)

Note:

Do not allow any gaps when aligning the front hooks.

Push in the claws on the rear side of the dome. (two each on the left and right)

Push until they are snapped on.

S2

Safety Working

When setting the Center Cover, fit the Lead Wire in the unit and avoid it from being caught inside the dome.

Ensure the Cable does not run in this area.

9-23