Panasonic CF-74JCJBD1 M service manual Setting the USB PCB, Arranging the USB Cable

Page 36

9.2.6.Setting the USB PCB

1.Fix the USB PCB to the computer using the two Screws<N9>.

2.Connect the USB Cable to the Connector (CN1701).

Screws <N9>: DFHE5025XA

Arranging the USB Cable

Safety Working	MP Slide Sheet
	Attach the MP Slid Sheet to prevent the Cable from coming off.

S2

<N9>

Fitting edge

CN1701

USB PCB

Connect

the Connector.

Pass it through the notch.

USB Cable

	Tape
Ensure the Cable does not
come out of the board edge	Pass it through
so that the Cable does not	Pass it through
touch the MP Drive.	the notch.

Avoid runnning over the boss.

MP Slide Sheet

A

Pass the Cable through

the notch and lead it downward.

Fit the surplus length of

the Cable into this side.

Fit the Cable between the pins.

Pass it through the rib.

Ensure the "A" end does not come on the level.

9-14

Image 36

Contents Model No. CF-74JCJBDxM For U.K Laser Safety Information Safety Precautions Precautions Battery Pack Contents Specifications Main Specifications Wireless LAN Names and Functions of Parts Right side Block Diagram Page Troubleshooting Power-On Self Test Boot Check Stuck key 02D0 System cache error Cache disabled Self Diagnosis Test Operation of PC-Diagnostic Utility Selection of tested device To skip Bios password Wiring Connection Diagram Battery Pack PreparationRemoving the HDD HDD UnitRemoving the Dimm Memory Card Removing the Handle Assy Removing the Bottom CaseRemoving the Wireless Module and MDC Module PCB Removing the Display unit Removing the Touch PAD and PAD PCB Removing the Finger PCBPreparation Reassembly Instructions Arranging the W-LAN L and R Cable Attaching the LCD Damper C and LCD Damper DArranging the LCD/TS Cable Attaching the ClothArranging the TP Power Cable and Attaching the TP/LCD Sheet Setting the Inverter and Arranging the Inverter CableLCD Unit Setting the LCD Front Cabinet Setting the Display unitFixing of the LCD Front Cabinet Setting the USB PCB Arranging the USB CableSetting the BT PCB Setting the SD PCB, Heat Sink FAN MotorApplying Grease on the Heat Sink Setting the DC-IN PCB and I/O PCB Arranging the DC-IN CableSetting the PC Card Ejector and Lithium Battery Arranging the Lithium BatteryArranging the FAN Cable Setting the Wireless Module and MDC Module Arranging the Modem CableSetting the Bottom Case Setting the Handle AssySetting the Speaker and the LED PCB Soldering the Speaker Cable and Setting the Speaker RubberSetting the Keyboard Center CoverSetting the Dimm Memory Card and Dimm Cover Setting the HDDLatch HDD Unit Battery Pack DVD-ROM Drive Unit Exploded View Screw tightening torque Screw tightening torque CF-74JCJBDxM Replacement Parts List Accessories NRPDFHR6204ZA MODELAN-2 DFHE0277ZA Gasket QTY EEFCX0D221REEFCX0D331R EEFUD0J151ER EEFSX0D331EREEFCX0G151R EEFCX0J101RConnector CONNECTOR, DimmCONNECTOR, USB ThermistorGigabit LAN Switch IC, FET SwitchPower Management Swtich IC, Audio Power AmplifierDC Power Line Inductor DC Power Line BeadsCommon Mode Filter Array DC/DC Controller for CPUB1GBCFNN0042 Transistor FETTRANSISTOR, FET ERJ2GEJ102X RESISTOR, 1/16W, 1KOERJ2RKF80R6X ERJ2RKF2371XERJ2RKF49R9X ERJ2RKF1002X RESISTOR, 1/16W, 10KOERJ2GEJ511X ERJ2RKF3241XERJ2RKF4530X ERJ2GEJ150XERJ2RKF2002X RESISTOR, 1/16W, 20KO ERJ2GEJ272XERJ2GEJ474X ERJ2RHD303X RESISTOR, 1/16W, 30KOERJ2RKF3161X ERJ2RKF2402X RESISTOR, 1/16W, 24KOERJ2GEJ221X ERJ2RKF1003XEVQPLDA15 Switch JackIC, Touchpanel Controller ERJ2GEJ822XDEARA8AJ473M Resistor Array ERJ2GEJ152XBluetooth Module IncuctorInductor B1GBCFNN0042 Transistor Transistor ERJ2GEJ103X RESISTOR, 1/16W, 10KO