]Y/C Signal Input Jacks [Y/C IN 1, 2, 3, 4, 5]
Connect YC signals to these jacks in using them as video input signals.
Caution
Do not connect a BNC coaxial cable to Video Signal Input Jack p in case of connecting YC signals to Y/C Signal Input Jack ]. Use either composite signals or YC signals as video input signals.
4 | 3 |
| Pin No. | Signal | ||
1 | Y GND | |||||
|
|
| ||||
2 | 1 | |||||
|
|
| ||||
2C GND
3Y
4C
AVideo Output Connectors [PGM OUT 1, 2]
Two sets of composite signals (BNC) consisting of the switcher's main output together with the wipe, mix, key or other effects added are output from these output jacks.
SPreview Output Connector [PVW OUT]
When the switcher is used for live applications, this connector enables the next operation to be previewed. (LOOK AHEAD PREVIEW)
•While the Fader Lever is at the
•When the PGM OUT Connectors are in the key OFF status, the PVW OUT Connector is set to the key ON status and the key synthesis status can be previewed.
The table below shows the correlation between the program output and preview output statuses.
| Bus selection | Key ON/OFF | ||
PGM OUT | Key ON | Key OFF | ||
PVW OUT | Key OFF | Key ON | ||
DGenlock Input/BB Output Connector [GLIN/BBOUT]
In compliance with the setting of the SETUP switch K, either the genlock input or BB output is selected.
Genlock input: To apply genlock to the switcher, connect this signal to the signal generator or other device.
BB output: At this position, the BB sync signal is output to apply genlock to a camera or other input device by synchronizing it to the switcher. In this case, the same signal as BBOUT F is output.
FBlack Burst Signal Output Connector [BBOUT]
Used to externally synchronize a input device connected to the Live Switcher. When externally synchronizing two or more devices, distribute the black burst output to them using a video distributor (VDA).
GY/C Video Output Connector [PGM Y/C OUT]
This connector delivers the Y/C signal video output which has the same function as the video output signal A.
Caution
Due to what is involved in the signal processing, the Y/C video output G has a phase which is delayed by 1 line compared with the composite video output A.
HAuto Take External Input Jack [EXT TAKE]
Use it for external auto take by applying a contact input. The operation is the same as when using Auto Take Switch u and Key Auto Switch I.
✽Use an M3.5 stereo single head plug for connection with this unit.
Connect the switches as shown below.
AUTO TAKE
KEY AUTO
16 | 17 |