About Your Projector
Remote control
Power button |
|
While the MAIN POWER |
|
button is on, switch between |
|
standby mode and projection |
|
mode. (page 21) | Remote control signal emitter |
| Emit remote control signal. (page 23) |
Display the PICTURE menu. |
|
(page 23) |
|
Switch to cycle through the
PICTURE MODE. (page 23)
Switch to cycle through the aspect ratio. (page 24)
Display the main menu or return to the previous menu. (page 29)
Navigate through the menus with FGIH, and activate the menu item with the ENTER button. (page 29)
Reset some of the settings to the factory default. (page 28)
Switch to cycle through the input method. (page 28)
Button backlight
When any button is pressed, the button backlight is lit. Without any operation, it gets darker after 5 seconds and goes of after next 5 seconds.
Display the LENS CONTROL menu. (page 23)
Display the MEMORY LOAD menu. (page 24)
Display the COLOUR MANAGEMENT menu. (page 26)
Display the input waveform. (page 24)
Return to the previous menu. (page 29)
Capture the projected image as a still image. (page 28)
Activate the assigned function from the menu options for shortcut. (page 42)
Preparation
Battery compartment
1.Press the tab and lift up the cover.
2.Insert the batteries according to the polarity diagram indicated inside.
NOTE:
•Do not drop the remote control.
•Avoid contact with liquids or moisture.
•Use manganese batteries or alkaline batteries with the remote control.
•Do not attempt to modify or disassemble the remote control. Contact an Authorised Service Centre for repairs.
•Do not keep pressing the remote control buttons as this may shorten battery life.
•See “Remote control operation” on page 23.