Basic Operation
Remote control operation
Operating range
You can operate the projector with the Remote control within the remote range 7 m.
Facing to the projector
Ensure the Remote control emitter is facing to the Remote control signal receptor on front of the projector and press the required buttons to operate.
Facing to the screen
Ensure the Remote control emitter is facing to the screen and press the required buttons to operate the projector. The signal will be reflected off the screen. The operating range may differ due to the screen material.
NOTE:
The Remote control may malfunction under strong light such as a fluorescent. Do not let strong light shine onto the signal receptor.
If there are any obstacles between the remote control unit and the receptor, the Remote control may not operate correctly.
Turning on the button backlight
In a dark room, you can turn on the button | After 30 seconds without any operation, the backlight |
backlight to operate the Remote control. | will go out. Press any but the LIGHT button to turn on |
Press the button on the upper right corner of | again. To escape from the |
the unit to turn on the backlight and enter | LIGHT button. |
the |
|
Resetting to the factory default settings
You can reset most of the customized |
| |
settings to the factory defaults by pressing |
| |
NOTE: | ||
DEFAULT button of the Remote control. | ||
Some menu items are not available to reset by | ||
Display the required sub menu or the menu | ||
pressing the DEFAULT button. Adjust each menu | ||
items and press the button again. See | ||
items manually. | ||
"Main menu and | ||
|
Capturing an image
When projecting an image, press FREEZE to capture the projected image and display it on the screen as a still picture. Press again to escape.
NOTE:
Escaping from the freeze mode is available by pressing any button except the LIGHT button.
22 - ENGLISH