Panasonic PT-AE2000U Adjusting the signal condition with a waveform, Displaying the waveform

Remote control operation

Adjusting the signal condition with a waveform

You can display the image brightness and
		Monitoring the waveform of
contrast level of the input signal with a
	FULL SCAN	brightness and contrast of the whole
waveform. See “WAVEFORM MONITOR”
		image.
on page 32.		Monitoring the waveform of
	SINGLE LINE SCAN	brightness and contrast in each
		horizontal line of the image.

100%

50%

0%

ENTER

ENTER

			Adjust to 100%
level	100%
Signal		50%
					dynamic range
	0%					Optimal
Adjust to 0%
				Monitor		position

		COMPUTER (except 1080)
		HDMI (Expand)
			Adjust to 100%
level	100%
Signal		50%
				dynamic range
	0%					Optimal
Adjust to 0%
					Monitor position

Displaying the waveform Adjustment example

Basic Operation

1.Press the WAVEFORM button and display the waveform monitor.

Press the WAVEFORM button again to escape from the waveform mode.

2.Press ENTER button until the required waveform option is displayed.

In FULL SCAN mode, press F G I H to change the waveform position.

In SINGLE LINE SCAN mode, press F G to select the required line position.

Project a commercial test signal for picture adjustment on the screen and press the WAVEFORM button.

Adjusting with luminance options

1.	Press the ENTER button until FULL SCAN(Y)/
	SINGLE LINE SCAN(Y) is displayed.
2.	Press the PIC. ADJUST to display the PICTURE
	MODE of the PICTURE menu.
3.	Press G several times to display the
	BRIGHTNESS.

FULL SCAN(Y)

FULL SCAN(R)

FULL SCAN(G)

FULL SCAN(B)

SINGLE LINE SCAN(B)

SINGLE LINE SCAN(G)

SINGLE LINE SCAN(R)

SINGLE LINE SCAN(Y)

4.	Adjust the BRIGHTNESS by pressing I H.
	Adjust the bottom line of the waveform to 0%
	(0 or 7.5 IRE).
	Setting range: -32 to +32
5.	Press G once to display the CONTRAST.
6.	Adjust the CONTRAST by pressing I H.

Adjust the bottom line of the waveform to 100% (100 IRE).

Setting range: -64 to +64

NOTE:

•In SINGLE LINE SCAN mode, the position of the waveform monitor depends on the position of the selected line.

•You can display the main menu by pressing the MENU button and adjust the menu items.

•The called up menu items displayed position depends on the position of the waveform monitor.

•You can activate AUTO ADJUST of the WAVEFORM menu by pressing the DEFAULT button.

•The signal which is lower than 0% in the waveform will be displayed as same as 0% on the projected image.

•While the waveform is displayed, the image is displayed without the COLOR MANAGEMENT adjustment.

•When adjusting the KEYSTONE of the POSITION menu while the waveform is displayed, xvYCC will be deactivated.

FULL SCAN(Y)/SINGLE LINE SCAN(Y)

BRIGHTNESS	Adjust the bottom line of the
	waveform to 0% (0 IRE or 7.5 IRE)
CONTRAST	Adjust the top line of the waveform
	to 100% (100 IRE)

24 - ENGLISH