TEMP and LAMP Indicators
Managing the indicated problems
If a problem should occur with the projector, the LAMP and/or TEMP |
| |
indicators will inform you. Manage the indicated problems as follow. |
| |
1. | Confirm the status of all indicators and projector, and switch off |
|
| the projector in proper way. |
|
2. | Find out the cause of the problem by status of the LAMP and/or | POWER LAMP TEMP |
| TEMP indicators. | |
|
| |
3.Follow the following instruction for each indication and solve the problem.
4.Turn on the projector in the correct way and confirm the indicator is not indicating a problem any longer.
NOTE:
• If no problem is found or the problem remains, do not turn on the projector. Instead contact an Authorized Service Center.
LAMP indicator
Indicator | Illuminating red | Flashing red |
|
| |
|
|
|
|
| |
Problem | LAMP RUNTIME has | The lamp circuit failure, abnormal function or lamp unit is damaged. | |||
reached 1 800 hours. | |||||
|
|
|
| ||
| The lamp unit will run | The MAIN POWER is |
|
| |
| switched on again | The lamp circuit failure, | The lamp unit is | ||
Cause | out soon and needs to | ||||
before the lamp unit is | abnormal function. | damaged. | |||
| be replaced. | cooled enough. |
|
| |
|
|
|
| ||
| See “Replacing the | Let the lamp unit cool | Contact an Authorized | See “Replacing the | |
Remedy | down and turn on the | ||||
lamp unit” on page 44. | Service Center. | lamp unit” on page 44. | |||
|
| MAIN POWER. |
|
| |
TEMP indicator
Indicator | Illuminating red and still projecting |
|
| ||
Flashing red and the POWER button is turned off |
|
| |||
|
|
| |||
Problem | The temperature inside and/or outside the projector is abnormally high. |
| |||
|
|
|
|
| |
| The ventilation | The room temperature | The air filter is | The projector is located | |
Cause | excessively dirty and | at high elevations | |||
| openings are covered. | is too high. | the ventilation is poor. | (above 1 400 m). | |
|
|
| |||
| Remove the object(s) | Reinstall the projector | Replace the air filter in | Turn on the projector | |
Remedy | from the ventilation | in temperature | the proper method. | and set the ALTITUDE | |
openings or clear | controlled place. See | to HIGH. | |||
| See page 43. | ||||
| around the projector. | page 52. | See page 41. | ||
|
| ||||
|
|
|
|
| |
Maintenance