Panasonic PT-AX200E manual Sleep, Lamp Runtime, Test Pattern, Altitude, Lamp Power

OPTION menu

SLEEP

You can select the required duration of time and set the off timer to turn off the power of the projector automatically. 3 minutes before turn-off, the countdown of minutes will be displayed in the lower right corner. Press I H to cycle through the options.

OFF 240MIN.

LAMP RUNTIME

You can check how long time the lamp has been used.

NOTE:

•LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Replacing the lamp unit” on page 42.

60MIN.

90MIN.

120MIN.

210MIN.

180MIN.

150MIN.

TEST PATTERN

You can use the 2 different test patterns to adjust the focus of the image.

1.Press the ENTER button to display the test pattern 1 and adjust the focus with the focus ring.

ALTITUDE

If you use the projector at high elevation, the ALTITUDE setting need to be HIGH to set the fan speed high. Press I H to select the required option.

LOW	The fan speed is low.
HIGH	The fan speed is high.

NOTE:

•At 1 400 m (4 593 ft) above sea level, the setting must be HIGH.

•The loudness of fan noise depends on the ALTITUDE setting.

LAMP POWER

You can adjust the power of the lamp to save electricity, prolong the lamp life and reduce the noise.

Options	Function
NORMAL	When higher luminance is
	required.
ECO-MODE	When lower luminance is
	sufficient.

2.Press the ENTER button to display the test pattern 2 and adjust the focus with the focus ring again.

3.Press the MENU or RETURN to return to the previous menu, or press repeatedly to return to the screen.

NOTE:

•When the projector and/or the screen is tilted, adjust the focus at the centre of the image. The upper and lower edge might be out of focus.

•When the image is distorted in keystone, adjust the KEYSTONE in the POSITION menu.

Settings

NOTE:

•When no input signal is detected, the function is disabled.

ENGLISH - 39