Care and Replacement
Replacing the lamp unit
Before replacing the lamp unit
Switch off the MAIN POWER button in proper way and disconnect the mains plug from the mains socket. Make sure the lamp unit and the surroundings are cooled enough.
Unplug all the cables from the projector. Prepare a
Contact an Authorised Service Centre to purchase a replacement lamp unit
When the projector is mounted in the ceiling, do not work directly under the projector or put your face closer to the projector.
NOTE:
•Prior to replacing the lamp unit, allow it to cool down to prevent the risk of burns, damage and other hazards.
•Do not attempt replacement with an unauthorised lamp unit.
When to replace the lamp unit
The lamp unit is consumable and the brightness decreases by duration of usage. The LAMP indicator will inform you of the replacement timing at 1 800 hours, and at 2 000 hours, the projector will be turned off. Those figures are rough guidance and might be shortened by the usage conditions, characteristics of the lamp unit, environmental conditions, and so on. You can check the duration of usage time using LAMP RUNTIME in the OPTION menu.
On screen | LAMP indicator |
Indication | REPLACE LAMP |
|
|
| |
|
|
|
| “REPLACE LAMP” is displayed on the upper left |
|
Over 1 800 hours | of the screen for 30 seconds. |
|
To clear the screen immediately, press any |
| |
|
| |
| button. | Illuminates red. |
| “REPLACE LAMP” is displayed on the upper left |
|
Over 2 000 hours of the screen, and it will stay until you respond. |
| |
| To clear the screen, press any button. |
|
NOTE:
•The guide times, 1 800 and 2 000 hours, are rough estimates based on certain conditions and is not a guaranteed time. The estimated condition is: LAMP POWER in OPTION menu set to NORMAL.
•To prolong the lamp life, set the LAMP POWER in OPTION menu to
•For more information about the lamp unit, such as guaranteed time, see the instructions which is provided with the lamp unit.
Maintenance
42 - ENGLISH
http://www.pureglare.com.au