Panasonic PT-AX200E manual Serial terminal

Technical Information

Serial terminal

The serial connector which is on the connector panel of the projector conforms to the RS-232C interface specification, so that the projector can be controlled by a personal computer which is connected to this connecter.

Connection

D-sub 8 pin (male)

	Serial terminal adapter	Serial terminal (female)
Computer	(ET-ADSER: Optional)

Appendix

NOTE:

• You must use only an RS-232C Serial Interface Cable with a ferrite core, type ET-ADSER.

Pin assignments and signal names

Pin No.	Signal name	Contents
A		Connected internally
B		Connected internally
C	RXD	Received data
D	GND	Earth
E	TXD	Transmitted data
F		Connected internally
G		NC
H		NC
Cable specifications	NC	NC

(When connected to a personal computer)

						Projector	NC		NC	PC (DTE)
							NC		NC
							NC		NC
Basic format
								The data streaming from the computer will
STX		Command		:	Parameter	ETX
								start with STX, and proceed to Command,
Start	byte							Parameter and end with ETX. You can
			1 byte			End
		3 bytes			1 byte -
(02h)						(03h)		add the required parameter.
					4 bytes

The projector can not receive any command for 10 seconds after the lamp is switched on. Wait 10 seconds before sending the command.

If sending multiple commands, check that a response has been received from the projector for one command before sending the next command.

When a command which does not require parameters to be sent, the colon (:) is not required.

If an incorrect command is sent from the personal computer, the ER401 command will be sent from the projector to the personal computer.

46 - ENGLISH

http://www.pureglare.com.au