Panasonic PT-AX100U manual Projection method, Front leg adjuster and throwing angle, Setting up

Page 15

Setting up

Projection method

You can use the projector with any of the following 4 projection methods. To set the desired method in the projector, see “INSTALLATION” on page 35.

Setting on a desk/floor and	Setting on a desk/floor and
projecting from front	projecting from rear

Getting Started

INSTALLATION: FRONT/DESK

Mounting in the ceiling and projecting from front

INSTALLATION: FRONT/CEILING

INSTALLATION: REAR/DESK

Mounting in the ceiling and projecting from rear

INSTALLATION: REAR/CEILING

NOTE:

A translucent screen is required for REAR projection.

When mounting the projector in the ceiling, the optional ceiling mount bracket (ET-PKX100) is required.

Front leg adjuster and throwing angle

You can adjust the throwing angle by screwing the front legs up/down.

This adjust the angle of the projector.

NOTE:

Heated air comes out of the Air exhaust port. Do not touch the Air exhaust port directly. If keystone distortion occurs, see “KEYSTONE” on page 33.

ENGLISH - 15

Image 15

Contents Operating Instructions Dear Panasonic Customer Important Safety NoticePanasonic Important Safety NoticeContents Settings MaintenanceAppendix Precautions with regard to safety Do not look into the lens while the projector is being used Precautions with regard to safetyDo not place any heavy objects on top of the projector Do not put your weight on this projectorDo not cover the air inlet port or the air outlet port Always disconnect all cables before moving the projectorBefore use AccessoriesBefore use Remote control About Your ProjectorFront, back and top view Control panel Projector About Your Projector Top and front viewTerminals Back and bottom viewSetting up Calculation methods for screen dimensionsScreen size and throw distance Front leg adjuster and throwing angle Setting upProjection method Vertical shift Adjusting the Shift leverLens shift and positioning Horizontal shiftAdjustable projection range Projector location rangeAfter fixing the screen position Before connection to the projector Connecting with AV devicesConnecting with HDMI/PC ConnectionsConnecting Switching the projector on/offPower cord Power indicatorPower indicator Switching on the projectorSwitching off the projector Switching the projector on/offFocus ring Zoom ring Selecting the input signalProjecting an image Positioning the imageCapturing an image Remote control operationInput switching Operating rangeSwitching the picture mode Switching the aspect ratioSwitching off the projector automatically Resetting to the factory default settingsAdjusting the image Setting your own color profileCreate a new profile Saving a log setting as a profile Loading saved profilesManaging stored logs Main menu Menu NavigationNavigating through MenuMenu Navigation Sub-menuBrightness Picture ModePicture Menu ContrastDynamic Iris Color TemperatureTint SharpnessNR Noise Reduction Signal ModeFavourite Save Favourite LoadDOT Clock Clock PhasePosition Menu PositionAspect ratio options and projection example Component signalsAspect Position MenuOver Scan Auto SetupAspect ratio depend on signals WSSOption Menu Altitude InstallationLamp Power SleepControlling alerts Temp and Lamp IndicatorsLamp indicator Temp indicator Lamp indicatorCare and Replacement Before cleaningCleaning your projector When to replace the Lamp unit Care and ReplacementBefore replacing the Lamp unit Resetting the Lamp Runtime Replacing the lamp unitReplacing Troubleshooting Technical Information List of compatible signalsTechnical Information Pin assignments and signal namesCommunication settings Serial terminalBasic format Control commandsInquiry commands Cable specificationsProjector Option Menu 34 H Menu structurePicture Menu 28 H Position Menu 31 HNTSC/NTSC 4.43/PAL/PAL-M/PAL-N/SECAM SpecificationsSerial SpecificationsDimensions Trademark acknowledgements Altitude IndexOSD Design OSD Position Over Scan Index

Related manuals

Manual 52 pages 37.79 Kb