Projecting an image
Selecting the input signal
1. Switch on the connected devices. | 2. Press the INPUT SELECT button to select the |
Press the play button of the required device. | required input method if needed.See "Input |
| switching" on page 22. |
| The image will be projected on the screen. |
NOTE:
AUTO SEARCH is ON as default and the signal from the connected devices is detected automatically. See "AUTO SEARCH" on page 34.
Positioning the image
1.Press ASPECT to select the required aspect mode. See "ASPECT" on page 32.
2.Adjust the projected image with the Shift lever. See "Lens shift and positioning" on page 16.
Unlock
3. Adjust the angle of the projector.
Screw down the Front leg adjuster and adjust the angle vertically.
NOTE:
Do not touch the Air exhaust port as this may cause burns or injury.
If keystone distortion occurs, see “KEYSTONE” on page 33.
4.Adjust the focus and the projected image size.
Turn the Focus ring and Zoom ring to adjust the image.
You can confirm the result with TEST PATTERN.
Focus ring
Zoom ring
Basic Operation
ENGLISH - 21