Switching the projector on/off
Power cord
Ensure all the input devices are connected and turned off before connecting the Power cord.
Connecting
1. Make sure the shape of the power cord plug and the AC IN
connector on the back of the projector match,
then push the plug all the way in.
2. Connect the Power cord to a wall socket.
Disconnecting
1.Make sure the MAIN POWER is switched off and unplug the Power cord from the wall socket.
2.Hold the plug and unplug the Power cord from the AC IN connector on the back of the projector.
NOTE:
Do not use any other Power cord than the one supplied with the projector.
Do not force the connector as this may damage the projector and/or the power cord.
Dirt or dust
Switch off the power to the projector when not in use.
POWER indicator
POWER indicator
Indicator status | Status | ||
|
|
| |
No illumination or flashing | The MAIN POWER is switched off. | ||
|
|
| |
RED | Lit | The MAIN POWER is switched on and the projector is standby. | |
|
|
| |
GREEN | Flashing | The POWER is switched on and the projector is getting ready to project. | |
|
| ||
Lit | The projector is ready to project. | ||
| |||
|
|
| |
| Lit | The POWER is switched off and the projector is cooling the lamp. | |
ORANGE |
|
| |
Flashing | The POWER is switched on again when cooling the lamp and recovering | ||
| |||
| to projection mode. Recovery may take a while. | ||
|
| ||
|
|
|
NOTE:
While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Power cord.
Basic Operation
ENGLISH - 19