Panasonic PT-F200NTU/PT-FW100NTU, PT-F200NTE/PT-FW100NTE manual Wireless settings, Ssid ※

Network setting of the projector (cont.)

Wireless settings

Select [NEXT] on the IP address setting window to switch to the wireless setting window.

Make the settings related to the wireless connection between the projector and the network.

WIRELESS DETAILED SETUP

	USER1		2/3
	SSID	Panasonic Projector
	MODE		AD HOC
	AUTHENTICATION		OPEN
RETURN	ENCRYPTION		NONE
	CHANNEL		1
SELECT
ENTER	RETURN	NEXT	CANCEL

SSID※	: If the mode is [INFRASTRUCTURE※], enter the SSID registered at the access point. If the mode is
	[AD HOC], enter the same character string as that of SSID set on the computer to be connected.
MODE	: Select [AD HOC] or [INFRASTRUCTURE].
AD HOC※	: Connect projector and computer directly without access point.
INFRASTRUCTURE※ : Connect through access point.
AUTHENTICATION : Set the user authentication method used by the network to be connected.
OPEN	: Select when making a connection using [AD HOC], or when the access point authentication method is
	OpenSystem※.
SHARED	: Select when making a connection using [AD HOC], or when the access point authentication method is
WPA-PSK※	Shared Key※.
	: Select when the access point authentication method is WPA-PSK.
ENCRYPTION : Select the encryption method to be used for communication between the projector and the network.
NONE	: Select when transmit without encryption. It is selectable only when [AUTHENTICATION] is [OPEN] or
WEP※	[SHARED].
	: Select when ENCRYPTION is WEP.
TKIP※	: Select when ENCRYPTION is TKIP.
AES※	Selectable when [AUTHENTICATION] is [WPA-PSK].
	: Select when ENCRYPTION is AES.
	Selectable when [AUTHENTICATION] is [WPA-PSK].

※“Glossary” (See page 45)

• If you are unable to connect to the wireless LAN through the access point even after performing the steps in “ Projector settings (See page 15),” contact the manufacturer of the access point.

• This projector does not conform to WPA2, IEEE 802.1x.

30