Panasonic PT-F200U manual Position menu

POSITION menu

Remote control Control panel

See “Navigating through the MENU” on page 27. See “Main menu and Sub-menu” on page 28.

DOT CLOCK

If you have interference patterns of the projected image, which is sometimes referred to as moire or noise, you can minimize it by pressing I H to adjust the clock frequency. (Available with signals from COMPUTER only)

Settings

KEYSTONE

If the projector is aligned non-perpendicularly to the screen, or if the projection screen has an angled surface, you can correct keystone.

Image Operation

NOTE:

•You can correct the distortion ± 30 degrees from the plane. For a better quality image, installing the projector with a minimum of distortion is recommended.

•Some distortion may be retained for lens shift adjustment.

•The distortion of the Main menu screen is not correctable.

•The result of the keystone correction will affect the aspect ratio and the size of the image.

POSITION

You can move the projected image for fine adjustment. Press I H to move horizontally and F G vertically. (Available with signals from VIDEO/S-VIDEO/ COMPUTER/COMPONENT only)

POSITION	H
	V

NOTE:

•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference.

•DOT CLOCK needs to be adjusted before adjusting the

CLOCK PHASE.

CLOCK PHASE

If you require further adjustment for the same reason as the DOT CLOCK adjustment, you can fine adjust the timing of the clock. Press I H to adjust. (Available with signals from COMPUTER/COMPONENT only)

NOTE:

•If the projecting signal’s dot clock frequency is higher than 108 MHz, the adjustment may not make a difference.

ASPECT

You can switch the aspect ratio manually when needed. Press I H to cycle through the options.

4:3

S4:3

16:9

4:3

The input signal will be projected without any change.

ENGLISH - 32