Panasonic PT-F200U manual Option menu

OPTION menu

Settings

Remote control Control panel

See “Navigating through the MENU” on page 27. See “Main menu and Sub-menu” on page 28.

INPUT GUIDE

When you change the input method, the guidance appears in the upper right corner of the screen. The following display methods are available. Press I H to cycle through the options.

Options	Function
OFF	Turn off the guidance.
	Display the input method by text.
SIMPLE	The INPUT GUIDE will go out after
	5 seconds without any operation.
	Display the input method by graphic.
	The INPUT GUIDE will go out after
	10 seconds without any operation.
DETAILED	If you select any COMPUTER
	terminal which has no signal, the
	computer connection guidance will
	be displayed. See “Computer
	connection guidance” on page 46.

STARTUP LOGO

You can switch the logo on/off that is displayed when starting up the projector. Press I H to select the required option. STARTUP LOGO will be displayed for 30 seconds.

ON	Active
OFF	Deactive
USER	Display the original text

Editing the original text

If you select USER, you can display the 2 lines of original text up to 40 characters in 1 line instead of the logo.

TEXT CHANGE

1.Select USER and press ENTER.

2.Select the required line to enter or edit the original text, and press ENTER.

3.Use F G I H to specify the location of the required character and press ENTER.

The selected character will be displayed in the box. Select DELETE to delete the last entered character and press ENTER.

4.Repeat the step 3 until you finish the text to display in a line.

5.Select OK and press ENTER to set the entered text in a box.

Press G and edit the TEXT2 if you need to, and repeat the step 3 - 5.

COMPUTER2 SELECT

You can switch the function of the COMPUTER2 IN/ 1 OUT terminal.

INPUT	COMPUTER2 IN
OUTPUT	COMPUTER1 OUT

FILTER REMAINING

You can check the remaining amount of the ARF (Auto Rolling Filter). The color of the bar scale is indicating the condition of the ARF.

Yellow	The filter remaining amount is getting
	low.
Red	No more remaining.

NOTE:

•See “Replacing the ARF (Auto Rolling Filter)” on page 40.

•After you replace the ARF, FILTER REMAINING should be reset to “0” by pressing the ENTER button for 3 seconds.

LAMP RUNTIME

You can check how long the lamp has been used.

NOTE:

•LAMP RUNTIME is a relevant matter for lamp replacement timing. See “Replacing the Lamp unit” on page 41.

•When the lamp unit is replaced with the new one (ET-LAF100), the setting will be reset to “0”.

	DELETE
OK	CANCEL

ENGLISH - 34