Zebra Technologies manual Maintenance pg, P4T Series Battery, LED Status Charger Status, Output

P4T/RP4T User Guide

Manual Introduction	RP4T Printers 35
pg.	pg.
4
P4T Overview- pg. 5	Maintenance pg. 36

Figure 4: Charging the P4T Series Battery with the LI72 Single Charger

Battery Charging

Receptacle

Mains connector will vary with country of intended use.

LI72 Battery

Charger

					P4T Series Battery
PrinterPreparation pg. 7		Troubleshootingpg.			Pack
	38		Charging Battery Packs with the AT18737-xx LI72 Single Charger
			Plug the LI72 into the appropriate AC wall receptacle, then insert the charge cable into the battery pack charger jack.
			The amber/green charge indicator LED will indicate the status of the charger as per the following table.
Connectingthe Printerpg.27		Specificationspg.
	43				LED Status			Charger Status
					Green Solid	Fully Charged
					Amber Solid	Charging
						•	Battery Contact Problem
RadioRegulatory Informationpg.31	Appendicespg.46						1. Short Circuit of Output Terminals
					Amber Blinking		2. Detection of Short Battery's Circuit
							3. No Contact + Terminal
						•	Over Voltage Protection
						•	Over Current Protection
						•	Temperature Waiting Time
				Operating Temperature				0 to 40o C @ 30-85% Relative Humidity
				Storage Temperature				-30 to 60o C @ 10-90% Relative Humidity
	Index			Input Voltage				AC100 to 240V 47 to 63Hz
				Input Current				0.18A MAX
	pg. 52			Output				DC 8.4V 800mA

10