P4T/RP4T User Guide
Manual Introduction | RP4T Printers 35 | |
pg. | pg. | |
4 |
|
|
P4T Overview- pg. 5 | Maintenance pg. 36 | |
Printer Preparation pg. 7 | 38 | Troubleshooting pg. |
Connecting the Printer pg. 27 | 43 | Specifications pg. |
Radio Regulatory Information pg. 31 | Appendices pg. 46 | |
| Index pg. 52 |
Charging the P4T Series Battery with the
Figure 4A: Charging the P4T Series Battery with the AC Adapter
AC Power Cord (varies with
location)
P4T Series AC
Adapter
p/n
Open the protective cover for access to the charger receptacle
•Open the protective cover on the P4T Series printer to expose the charger jack and the communication ports.
•Connect the appropriate AC power cord for your location to the adapter and then plug the power cord into an AC receptacle.
•Plug the barrel plug from the
•The printer will power up and begin charging. The printer can be left on or turned off at this point. Charging will continue in either state.
The following table details how the AC Adapter and P4T Series printers interact:
Printer | Charging | Printer LCD | Power Button Operation | |
Status | Status |
|
| |
Off | Off | Off | Pressing turns printer On | |
On | Off | Normal display operation | Pressing turns printer Off | |
|
| Normal display operation, plus | Pressingswitchesprintertolimited | |
On | On | battery icon will cycle through | operation:onlybatterycharging& | |
levelbars.Chargingwillcontinue | LCD functional | |||
|
| |||
|
| as required.. |
| |
|
| Battery icon will cycle through | Pressing turns printer On. Printer | |
Off | On | levelbars. Printerturnsoffatend | will run normally | |
|
| of charge cycle. |
|
Note: If the battery is out of its safe charging temperature range (either too hot or too cold) the printer will display the following: “Charging will resume when battery is in the range
flash and . Once the battery reaches a safe charging temperature, normal charging will automatically resume.
Section Continues | 11 |