Zebra Technologies P4T manual Installation Guidelines DC Adapter

P4T/RP4T User Guide

Manual Introduction	RP4T Printers 35
pg.	pg.
4
P4T Overview- pg. 5	Maintenance pg. 36
Printer Preparation pg. 7	38	Troubleshooting pg.
Connecting the Printer pg. 27	43	Specifications pg.
Radio Regulatory Information pg. 31	Appendices pg. 46
	Index pg. 52

Installation Guidelines (DC Adapter)

CAUTION: Insure that the adapter and cable you are using for this installation are clearly labeled for use with the vehicle's voltage. Failure to match the adapter's capacity to the vehicle's voltage could result in improper printer operation, or severe damage to either the printer and/or the adapter.

Note: It is the installer's responsibility to insure correct wiring and installation.

Note: Zebra is not liable for damage to any equipment caused by improper installation or wiring of the adapter, or damage resulting from use of the wrong adapter for the intended application.

Note: Do not lengthen the adapter's power cable or remove the cable's ferrite if equipped. Extending the cable or removing the ferrite may affect the adapter's reliability and radio frequency interference (RFI). Use care when attaching the adapter's power cable and power source. The red wire attaches to the positive (+) and the black wire to the negative (-) terminal. If wired backwards the adapter will be rendered inoperable and will need to be replaced.

General Guidelines

•Completely install the input power (battery) cable before connecting the unit(s).

•Route the input power from the general area where the unit(s) will be mounted.

•Use a snap-in bushing if the input power passes through the firewall or other sheet metal.

•Make sure that cable routing does not interfere with other equipment or vehicle controls.

•Make sure that cable routing does not expose the cable to potential physical damage.

•Secure the input power at least every 12 inches (30 cm) throughout the cable run.

Section Continues 14