RF-Mouse ID code, Connecting the RF-Mouse ID Code

97872 Instructions.quark 2/26/02 1:25 PM Page 5

Windows 95/98/Me/2000/NT4.0 installation

1.Connect the mouse to your computer.

2.Insert the installation diskette into your floppy disk drive.

3.Click the Start button and then click Run.

4.In the Run dialog window, type A:\setup, where "A" is the letter of your floppy disk drive.

5.Click OK and follow the instructions on your screen to complete the installation.

The RF-Mouse ID code

Each RF-Mouse is assigned a unique ID code when manufactured, to only pick up the signal from your mouse and prevents other RF-Mouse radio signals from operating on your computer. This feature can also be disabled, allowing other RF-pointing devices to operate your computer.

Connecting the RF-Mouse ID Code

When the driver installation is finished your computer reboots and the RF-Mouse window (shown on the right) appears.

SET ID CODE: Move the RF-Mouse for a few seconds to establish a connection, then click Connect ID. The unique ID code of your mouse is recognized and another RF pointing device will not function on your computer.

EXIT: Click Exit if no other RF pointing devices are

within 3 meters range or if you want other RF pointing devices to be able to access your computer.